Locate the two 10' 1" diameter sections of PVC pipe.

Cut each pipe into a 6 foot section.

Cut two additional lengths that are 6 inches taller than the length of the 1.25" diameter PVC that you used in Part 1 - the Buckets.

Take one of the 1" to 1" straight joiners and glue it onto one end of each of the two shorter sections. These are your leg extenders.

Take a 1" to 1" Tee shaped joiner and glue it onto one end of each of the two 6' legs

Set all of these aside to dry. Remember this cement is highly toxic so use it outdoors or in a well ventilated area.

Take the remaining section of 1" PVC pipe and cut it to 5' in length. This will be the crossbar.

Locate the two 1/2" by 5' long sections of PVC Pipe. Glue an endcap onto one end of each. These are your sheet end weights.

Fill with sand or dry soil, and when full glue the other endcap in place.

Set all of these glued leg pieces aside to dry for at least 1 - 2 hours.